The Enable-IT™ 820 Unpowered PoE & Ethernet Extender Kit is the worlds only unpowered extender to combine Voice, Ethernet and PoE all into one simple solution for IP Camera Extension or WiFi Access Point Extension at high speed. These elegant units are ideal for installing any WiFi Wireless Access Point, Security camera or other PoE powered equipment. They solve the high costs associated with stretching your backbone with traditional fiber or a series of hubs/repeaters and power requirements for your equipment.

This is the one and only Remote Unpowered Power over Ethernet (PoE) & Ethernet Extender in existence today.

The 820 units are a pair of Ethernet line drivers that utilize existing Voice CAT2 Telco wiring or better that drives your Ethernet data, dual voice lines and Power Over Ethernet up to 900ft or 275m distance over a 4-Pair (8 wire) telephone line or CAT5 cabling. No power required at the remote end, No Firmware to upgrade or manage. These units are easy and rapid to install with plug and play RJ-45 Ethernet jacks to quickly insert your wiring and go.

The 820 Ethernet extenders can be used on live voice wiring transparently; try that with your expensive Cisco LRE. No other Ethernet Extender manufacturer supports voice over the same pair of wire with data, and none have the capabilities of adding PoE in one solution.  Only Enable-IT 820 Super PoE extenders can.
Made in the USA with quality and pride - the only manufacturer to do so in this industry.

The design methodology would be to think of the 820 extending a standard Ethernet line up to 900' (275m) including existing dual voice lines simultaneously with 48v of power to drive your remote PoE devices. To increase the durability and extended use of the product providing maximum future technology protection, The 820 Extended Ethernet Units meet the challenge of modern switched LANs and allows you to add features and capacity as your network expands. The 820 units have been tested to provide sustained full duplex transport up to 15MB/s over CAT3 cabling or better.

• Superior performance and lowest cost over any competing technology.
  
• Longest warranty protection included exceeding any knockoff competitors.
  
• Broadband Ethernet Technology that delivers extended Ethernet over existing 2 pair telephone wiring or better up to 900' including active dual POTS line. This means no new wiring is required.
• Provides one scalable infrastructure for Internet access, POTS, VoIP, video, and virtual private networking.
• Quick install RJ-45 connection to infrastructure for voice in and voice & data out.
• Pricing ($399) is for a complete solution This kit includes the following:
  • (2) 820 LRE units
  • (2) 10' Black Ethernet patch cords
  • (1) Enable-IT 350 48V PoE Injector
  • (1) Country specific 5v/2A switching wall power adapter
  • (1) 820 Ethernet Extender Installation Manual

Power

CO unit - 5v/2A DC country specific AC switching wall adapter included. (120-260VAC)

CPE unit - unpowered Ethernet switch with 48V PoE passthrough to end PoE device

Data Rate

15Mbps full-duplex Ethernet Data & with simultaneous Voice transmission

Requires managed Ethernet switch port to be set at 10Mb if not used with included PoE injector

Interface

Ethernet: (1) LAN RJ-45 Standard 10 Base-TX port

Voice Lines: RJ-11 - Dual telephone line port

Dimensions

Height 3" (85mm)  Depth 1.5" (40mm)  Width 2" (60mm)

Environment

Operational Temperature: -13°F to 140°F (-25°to 60°C)

Humidity: 5% to 90%, non-condensing

Enclosure

Square wallmount plastic casing with Telco / Network port runs 25% cooler than any metal casing competitor