Today is November 22, 2014
Enable-IT 1 Watt 2.4GHz WiFi Amplifier/Booster
This is a 1 Watt 2.4 GHz 802.11g bi-directional amplifier designed for indoor or outdoor use and includes a 48v Power-Over-Ethernet (PoE) injector. The Amplifier has a built in PoE splitter that allows for powering the Amplifier and one additional
RJ-45 PoE device such as a WiFi radio or Access Point.
This RF amplifier is compatible with IEEE 802.11 (B/G/N) wireless LAN equipment and supports the 108Mbit/sec "Turbo Mode" radio feature found in many common brands of WiFi equipment.
The Active Power Control circuitry and firmware monitors the amplifier's output power and automatically adjusts to provide maximum output power regardless of cable length. This kit is ideal for indoor use, however it can be protected for outdoor use. The included PoE injector features integral lightning and surge protection individually protects the 4 data lines as well as protection for the power lines. The PoE injector allows for the installation of the Amplifier up to 328ft away from your LAN & power source and Enable-IT can provide PoE Extender & Ethernet extender kits to meet your distance needs.
This kit is bundled with our PoE injector as this amplifier is only compatible with it and the amplifier will provide an additional PoE Out port for your PoE equipment. This unique feature of a built-in PoE allows the WiFi amplifier to draw it's power from the same CAT5 cable used to pass Data and allow for an additional PoE device, simplifying your installation and costs.
A typical configuration would be to place this wireless amplifier near your Access Point/radio with a short coax segment from the output of your AP/radio to the male N-Type (RX) Receive connector and cable a Ethernet patch cord from the PoE out to the AP/Radio PoE/Data in. This kit includes a custom Cisco PoE patch cord for use with Cisco branded Access Points/Radios (Converts IEEE 802.3af standard PoE pinout to Cisco standard).